Xerox WorkCentre 5790 Series Service Manual page 1042

3. Remove the motor assembly, Figure
NOTE: As necessary, cut any tie wraps securing the crease roll motor harness.
1
Remove 3
screws
Figure 1 Motor assembly removal
Replacement
Reverse the removal procedure to replace the BM crease roll motor.
Repairs/Adjustments
REP 11.19-171, REP 11.20-171
1.
5
Pull the motor
assembly off
the shaft
4
Remove the
encoder disc
3
Disconnect
the motor
harness
2
Remove the circlip
REP 11.20-171 BM Backstop Motor Assembly
Parts List on PL 11.163
Purpose
This procedure is used to repair the following components:
• Ground wire, PL 11.163 Item
• Motor damper, PL 11.163 Item
• BM backstop motor, PL 11.163 Item
• BM backstop drive belt, PL 11.163 Item
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Open the HVF BM front door and fully pull out the BM module.
May 2013
4-304
1.
3.
4.
11.
WARNING
GP 14. Disconnect the power cord
WARNING
Xerox® WorkCentre® 5790 Family