Table of Contents
Advertisement
GP 32 How to Enable HTTP
Purpose
To enable the hyper text transfer protocol (HTTP) networking protcol.
Procedure
Perform the following:
1.
Enter Customer Administration Tools,
2.
Press the Machine Status button.
3.
Select the Tools tab.
4.
Select Network Settings.
5.
Select Network Setup.
6.
Select TCP/IP.
7.
Select HTTP/IPP Enablement.
8.
Select Enabled.
9.
Select Save.
10. Select Close.
11. Log out of Customer Administration Tools.
General Procedures/Information
GP 32, GP 33
GP
24.
GP 33 How to Configure the PWS to Ping a Device
Purpose
To configure the PWS to ping a device on a network.
Procedure
Perform the following:
1.
Set the IP address of the PWS one digit higher or lower than the device to be pinged. For
example, if the IP address of the device is 192.168.10.15, set the PWS to 192.168.10.14
or 192.168.10.16. To set the IP address of the PWS, refer to
2.
Set the subnet mask of the PWS the same as the devise to be pinged.
3.
On the PWS, Select Start, then Run.
4.
In the Run dialog box, type cmd.
5.
Select OK. A command window will open.
6.
In the command window, type ping and the address of the device. Refer to number 1 in
Figure
1.
7.
If the ping command is successful, a reply from the devise will be received. Refer to num-
ber 2 in
Figure
1.
Figure 1 Successful ping command
May 2013
6-60
GP
34.
Xerox® WorkCentre® 5790 Family
Advertisement
Chapters
Table of Contents
