Xerox WorkCentre 5790 Series Service Manual page 1488

Table 4 NVM chain 17 (image disk drive not used)
Location NVM Name NVM Description
17-001 Disk Mode Disk present.
17-002 Disk spin up Time before image disk
delay receives power
Table 5 NVM chain 19
Location NVM Name NVM Description
19-001 Megs of Mem- Amount of memory installed
ory
19-002 Resource% Resource percentage reported 0 to 99%
Reported
19-003 Use Partial Used partial blocks
Blocks
19-004 Mark mode Marking mode when EPC full
EPC full
19-005 Memory on Tar- Memory on target
get
19-006 Image Alloc Nominal compression ratio
Ratio
19-007 Print Img Limit Maximum number of network
controller images that can be in
EPC at any given time
19-008 EPC Setting Governs the setting of the EPC
low and intermediate thresh-
olds.
19-009 Ncomp EPC Number of images inputted
Simp Img No before a non-compiled simplex
print job is released for marking
19-010 Ncomp EPC Number of images inputted
Dup Img No before a non-compiled duplex
print job is released for marking
19-011 Comp EPC Number of images inputted
Simp Img No before a compiled simplex
print job is released for marking
General Procedures/Information
dC131b
Value Default Location NVM Name
1=enabled 0 19-012
0=disabled
0 to 30 seconds 10
Value Default
0 to 65535M 16
10
0 or 1 1
0 or 3 0
0 to 65535 32
1 to 50% 30
35 to 5000 3501
1 = Optimized for 1
smaller sheets,
A4/8.5x11inch.
EPC less than
256Mb.
2 = Intermediate
setting, optimized
for medium size
sheet
3 = Optimized for
large sheet, A3/
11x17 inch. EPC
greater than
256Mb
Range 1 to 50 2
Range 1 to 50 4
Range 1 to 50 2
May 2013
6-104
Table 5 NVM chain 19
NVM Description
Comp EPC Dup Number of images inputted
Img No before a compiled duplex print
job is released for marking
Value Default
Range 1 to 50 4
Xerox® WorkCentre® 5790 Family