Xerox WorkCentre 5790 Series Service Manual page 1112

REP 11.67-171 Tri-Folder Covers
Parts List on PL 11.190
Removal
Switch off the electricity to the machine. Refer to
from the customer supply while performing tasks that do not need electricity. Electricity
can cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove the front door then the front cover,
3
Remove 4 screws
then the front cover.
Figure 1 Tri-folder front door and cover
Repairs/Adjustments
REP 11.67-171
WARNING
GP 14. Disconnect the power cord
WARNING
Figure 1.
1
Remove 1 screw
then the front door
hinge pin.
2
Remove the door from the
upper pivot.
2. Remove the rear cover, the top cover and the right side cover as necessary,
NOTE: Open the top cover and remove the rear cover to access to the top cover rear fas-
teners and the top cover interlock sensor connector.
3
Open the front door to
access the top cover front
fasteners.
Figure 2 Top, rear and right side covers
Replacement
Reverse the removal procedures to reinstall the tri-folder covers.
May 2013
4-374
4
Remove the top cover (4 fasteners).
1
Remove the rear cover
(4 screws).
2
Remove the right hand side cover (5 screws).
Xerox® WorkCentre® 5790 Family
Figure 2.