Xerox WorkCentre 5790 Series Service Manual page 1208

2. Adjust the initial calibration of the inverter decurler:
a. Adjust the initial calibration, Figure
b. Run 20 duplex copies of the customers preferred print media or A4 / 8.5x11 inch
paper.
2
Turn the adjuster 1 increment clockwise to
increase down curl, or turn the adjuster 1
increment counter-clockwise to decrease
down curl.
Figure 2 Adjust the initial calibration
c. Assess the copies for curl, refer to IQ5. If output curl is evident then reset the inverter
decurler retaining ring to allow for further adjustment, refer to
Repairs/Adjustments
ADJ 10.1
2.
1
Insert a coin into the
slot of the adjuster.
Figure 3 and Figure
Figure 3 Increase down curl
3. Reset the inverter decurler retaining ring:
After the retaining ring is reset adjustments of a further 2 increments are enabled, 1 in
either direction.
a. Reset the position of the retaining ring. To increase the down curl on output copies,
see Figure 3. To decrease the down curl on output copies, see
4.
Figure 4 Decrease down curl
b. Run 20 duplex copies of the customers preferred print media or A4 / 8.5x11 inch
paper.
c. Assess the copies for curl, refer to IQ5.
May 2013
4-470
2
Turn the adjuster 1 increment
clockwise to increase down curl.
3
Align the indicator on the retaining
ring with the adjuster slot.
4
Tighten the screw.
1
Loosen the screw.
Figure 4.
2
Turn the adjuster 1 increment
counter-clockwise to decrease
down curl.
3
Align the indicator on the retaining
ring, central with the adjuster slot.
4
Tighten the screw.
1
Loosen the screw.
Xerox® WorkCentre® 5790 Family