Xerox WorkCentre 5790 Series Service Manual page 884

3. Remove the lower registration guide,
Figure 2 Bias guide removal
4. Remove the registration clutch, REP
5. Prepare to remove the registration drive roll assembly,
1
Remove the E-clip and
bearing.
Figure 3 Preparation
Repairs/Adjustments
REP 8.26
Figure 2.
1
Remove
2 screws.
2
Remove the bias guide.
8.27.
Figure 3.
2
Remove the E-clip, spring
washer and bearing.
6. Remove the registration drive roll assembly,
1
Remove the registration
drive roll assembly.
Replacement
1. Replacement is the reverse of the removal procedure.
2. Ensure that the ground strap is located between the frame and the bearing.
Ground strap
Figure 5 Ground strap location
May 2013
4-146
Figure 4.
Figure 4 Drive roll removal
Bearing
Xerox® WorkCentre® 5790 Family
Figure 5.