Adj 11.1-110 2K Lcss Bin 1 Level; Adj 11.2-110 Machine To 2K Lcss Alignment - Xerox WorkCentre 5790 Series Service Manual

ADJ 11.1-110 2K LCSS Bin 1 Level

Parts List on PL 11.10
Purpose
To ensure bin 1 is level, and achieve the best stacking performance.
Adjustment
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 14. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
1. Remove the bin 1 motor, refer to REP
2. Move bin 1 to the lowest position.
3. Slacken the screw on each belt clamp and adjust the position they sit on the belts to level
the tray. Lock the clamps.
4. Re-install the bin 1 motor, refer to REP
5. Switch on the machine, GP 14.
6. Enter dC330 code 11-033, Bin 1 Elevator Motor Cycle. Check that bin 1 cycles without
giving any fault indications.
Xerox® WorkCentre® 5790 Family
WARNING
11.5-110.
11.5-110.

ADJ 11.2-110 Machine to 2K LCSS Alignment

Parts List on PL 11.2
Purpose
To correctly align the 2K LCSS to achieve reliable transfer of paper from the machine to the 2K
LCSS.
Adjustment
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP
death or injury. Moving parts can cause injury.
1. Figure 1, turn both right hand wheels in the same direction to adjust the vertical alignment
between the 2K LCSS and the machine viewed from the front or rear.
Figure 1 Machine to 2K LCSS alignment
May 2013
4-471
WARNING
14. Disconnect the power cord. Electricity can cause
Repairs/Adjustments
ADJ 11.1-110, ADJ 11.2-110