Rep 7.28 Tray 3 And Tray 4 Elevate Damper Assembly (W/Tag 151) - Xerox WorkCentre 5790 Series Service Manual

REP 7.28 Tray 3 and Tray 4 Elevate Damper Assembly (W/
TAG 151)
Parts List on PL 7.18
Removal
Switch off the electricity to the machine,
customer supply while performing tasks that do not need electricity. Electricity can
cause death or injury. Moving parts can cause injury.
Take care during this procedure. Sharp edges may be present that can cause injury.
1. Remove tray 3 or tray 4, REP 7.2.
2. Remove the damper from tray 3, Figure
1
Remove two screws
Figure 1 Tray 3 damper removal
Repairs/Adjustments
REP 7.28
WARNING
GP 14. Disconnect the power cord from the
WARNING
1.
2
Lift the damper
to disengage the
bottom lugs,
then remove
3. Remove the damper from tray 4,
2
Lift the damper to disengage
the bottom lugs, then remove
Figure 2 Tray 4 damper removal
Replacement
1. The replacement is the reverse of the removal procedure. Refer to
the screws.
May 2013
4-110
Figure 2.
1
Remove two screws.
GP 6
Xerox® WorkCentre® 5790 Family
before refitting