Table of Contents
Advertisement
Upgrade Kit
Nitrogen Phosphorus Detector
Removing the Power Control Module
Material Needed
•
Six screws fix the Power Control Module. Two large Phillips screws are located
in the rear of the right hand-side of the GC, while the remaining four screws are
located just behind the front panel of the GC.
1. Remove the six screws. Refer to Figure 1-7.
2. Slide the Power Control Module very slowly and gently outward towards the
CAUTION
This operation requires particular attention because several cables are connected to
the Power Control Module. It must be removed gradually paying attention to
disconnect step by step all the cables available until the power control module is
completely free. Be very careful not to damage any wire during this operation.
16
Phillips screwdriver
1
Figure 1-7. TRACE GC Ultra Right Side View
rear of the GC. See Figure 1-8 on page 17.
1. Large Phillips Screws
Getting Started
1
Installation Guide
Advertisement
Table of Contents
