Table of Contents
Advertisement
vlan protocol group add protocol
Use the vlan protocol group add protocol command in Global Configuration
mode to add a protocol to the protocol-based VLAN groups identified by
groupid. A group may have more than one protocol associated with it. Each
interface and protocol combination can be associated with one group only. If
adding a protocol to a group causes any conflicts with interfaces currently
associated with the group, this command fails and the protocol is not added
to the group.
To remove the protocol from the protocol-based VLAN group identified by
groupid, use the no form of this command.
Syntax
vlan protocol group add protocol group-id ethertype value
no vlan protocol group add protocol group-id ethertype value
•
group-id — The protocol-based VLAN group ID, which is automatically
generated when you create a protocol-based VLAN group with the vlan
protocol group command. To see the group ID associated with the name
of a protocol group, use the show port protocol all command.
•
ethertype value — The protocol you want to add. The ethertype value can
be any valid hexadecimal number in the range 0x0600 to 0xffff.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to add the "ip" protocol to the protocol
based VLAN group identified as "2."
console(config)#vlan protocol group add protocol 2 ethertype 0xXXXX
Layer 2 Switching Commands
828
Advertisement
Table of Contents
