Default - H3C MSR810 Command Reference Manual

Views
PVC view
PVC-group view
Predefined user roles
network-admin
Usage guidelines
On an ATM interface, multicast or broadcast packets are sent through all PVCs or PVC-groups with
the broadcast attribute enabled.
You must configure this command on a PVC or PVC-group where broadcast or multicast packets
must be sent. For example, to establish PIM neighbors between two routers on an ATM link through
exchanging IP multicast packets, you must enable the broadcast attribute for PVCs on t he ATM
interfaces of both ends on the link.
This command is not applicable to PVCs in a PVC-group.
Examples
# Enable the broadcast attribute for PVC 0/100.
<Sysname> system-view
[Sysname] interface atm 2/4/1.1
[Sysname-ATM2/4/1.1] pvc 0/100
[Sysname-ATM2/4/1.1-pvc-0/100] broadcast

default

Use default to restore the default settings for an interface.
Syntax
default
Views
VE interface view
VE subinterface view
Predefined user roles
network-admin
Usage guidelines
CAUTION:
The default command might interrupt ongoing network services. Make sure you are fully aware of
the impacts of this command when you use it on a live network.
This command might fail to restore the default settings for some commands for reasons such as
command dependencies or system restrictions. Use the display this command in interface view to
identify these commands, and t hen use their undo forms or follow the command reference to
individually restore their default settings. If your restoration attempt still fails, follow the error
message instructions to resolve the problem.
Examples
# Restore the default settings of VE interface Virtual-Ethernet 2/4/1.
<Sysname> system-view
[Sysname] interface virtual-ethernet 2/4/1
195