Fr Lmi Type; Fr Map - H3C MSR810 Command Reference Manual

fr lmi type

Use fr lmi type to configure the Frame Relay LMI protocol type.
Use undo fr lmi type to restore the default.
Syntax
fr lmi type { ansi | nonstandard | q933a }
undo fr lmi type
Default
The Frame Relay LMI protocol type is q933a.
Views
Interface view
Predefined user roles
network-admin
Parameters
ansi: Specifies the standard LMI protocol defined in ANSI T1.617 Annex D.
nonstandard: Specifies the nonstandard compatible LMI protocol.
q933a: Specifies the standard LMI protocol defined in Q.933 Annex A.
Usage guidelines
The LMI protocol maintains the Frame Relay PVC table. It can perform the following operations:
• Notifies the addition of a PVC.
• Detects the deletion of a PVC.
• Monitors PVC status changes.
• Verifies link integrity.
The system usually supports the following LMI protocols:
• ITU-T Q.933 Annex A.
• ANSI T1.617 Annex D.
• Nonstandard compatible LMI protocol.
Examples
# Configure the Frame Relay LMI type as nonstandard compatible protocol on Serial 2/1/0.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] fr lmi type nonstandard

fr map

Use fr map to create a static address-to-DLCI map.
Use undo fr map to delete a static address-to-DLCI map.
Syntax
fr map ip { ip-address | default } dlci-number
fr map ipv6 { ipv6-address | default } dlci-number
undo fr map ip { ip-address | default } dlci-number
347