Pppoe-Server Access-Line-Id Content - H3C MSR810 Command Reference Manual

undo pppoe-server access-line-id circuit-id trans-format
Default
The transmission format for the circuit-id in access line ID is a string of characters on an interface.
Views
Layer 3 Ethernet interface/subinterface view
Layer 3 virtual Ethernet interface/subinterface view
VLAN interface view
Layer 3 aggregate interface/subinterface view
VE-L3VPN interface/subinterface view
EFM interface/subinterface view
Predefined user roles
network-admin
Parameters
ascii: Specifies the character string format. For example, the circuit-id 00010002 is transmitted in the
form of 01 08 30 30 30 31 30 30 30 32.
hex: Specifies the hexadecimal format. For example, the circuit-id 00010002 is transmitted in the
form of 01 04 00 01 00 02.
Examples
# Configure GigabitEthernet 1/0/1 to use the hexadecimal format to transmit the circuit-id.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] pppoe-server access-line-id circuit-id trans-format hex

pppoe-server access-line-id content

Use pppoe-server access-line-id content to configure the content of the nas-port-id attribute
delivered to the RADIUS server on an interface.
Use undo pppoe-server access-line-id content to restore the default.
Syntax
pppoe-server access-line-id content { all [ separator ] | circuit-id | remote-id }
undo pppoe-server access-line-id content
Default
The nas-port-id attribute contains only the circuit-id on an interface.
Views
Layer 3 Ethernet interface/subinterface view
Layer 3 virtual Ethernet interface/subinterface view
VLAN interface view
Layer 3 aggregate interface/subinterface view
VE-L3VPN interface/subinterface view
EFM interface/subinterface view
77