H3C MSR810 Command Reference Manual page 242

Parameters
vpi: Specifies the VPI value in the range of 0 to 255.
scr: Specifies the sustainable cell rate in kbps. For more information about the value range,
see Table 47.
Usage guidelines
A VP is the collection of all PVCs with the same VPI value. VP policing is used to manage the
maximum bandwidth of the VP, and monitor the traffic of the inbound and outbound directions of the
VP on a physical interface. When the maximum transmission rate of the VP exceeds the specified
value, the exceeded flows are dropped.
When VP policing is applied, the parameters of PVC are still valid. Packets can be transmitted or
received only when the parameters of PVC and VP policing are met. In calculating the traffic, the
LLC/SNAP, MUX, and NLPID headers are included, but the ATM cell header is not included.
Examples
# Set the flow of the VP with VPI value 1 to 2 Mbps.
<Sysname> system-view
[Sysname] interface atm 2/4/0
[Sysname-ATM2/4/0] vp limit 1 2000
Related commands
service cbr
service ubr
service vbr-nrt
service vbr-rt
230