H3C MSR810 Command Reference Manual page 320

Field
Internet protocol processing
Hold timer
retry times
LCP: initial
Physical
Output queue - Urgent queuing:
Size/Length/Discards
Output queue - Protocol
queuing: Size/Length/Discards
Output queue - FIFO queuing:
Size/Length/Discards
Last clearing of counters: Never
Last 300 seconds input rate
Last 300 seconds output rate
Input: 0 packets, 0 bytes, 0
dropped
Output: 0 packets, 0 bytes, 0
dropped
Brief information on interface(s)
under route mode:
Link: ADM - administratively
down; Stby - standby
Protocol: (s) - spoofing
Interface
Link
Protocol
Main IP
Description
Network layer protocol state of the dialer interface.
Interval for sending keepalive packets.
Maximum number of keepalive retransmission attempts. A link is
removed after the maximum number of retransmission attempts is
reached.
LCP initialization is complete.
Physical interface type.
Statistics on the packets in the urgent output queue.
Statistics on the packets in the protocol output queue.
Statistics on the packets in the FIFO output queue.
Time when the reset counters interface command was last used to
clear the interface statistics. This field displays Never if the reset
counters interface command has never been used on the interface
since device startup.
Input interface data rate during the latest 300 seconds.
Output interface data rate during the latest 300 seconds.
Statistics on the packets reaching the interface.
Statistics on the packets sent through the interface.
Brief information about Layer 3 interfaces.
Link status:
• ADM—The interface has been administratively shut down. To
recover its physical state, execute the undo shutdown command.
• Stby—The interface is operating as a standby interface. To display
the active interface, use the display interface-backup state
command (High Availability Command Reference).
If the data link layer protocol state of an interface is shown as UP, but its
link is an on-demand link or not present at all, its protocol attribute
includes the spoofing flag (an s in parentheses).
Abbreviated interface name.
Physical link state of the interface:
• UP—The interface is up.
• ADM—The interface has been administratively shut down. To bring
up the interface, execute the undo shutdown command.
• Stby—The interface is operating as a standby interface.
Data link layer protocol state of the dialer interface:
•
UP.
•
DOWN.
• UP(s)—The interface is up, but its link is an on-demand link or not
present at all.
Primary IP address of the interface.
308