Ppp Mp Max-Bind - H3C MSR810 Command Reference Manual

Examples
# Set the maximum LFI fragment size to 80 bytes on MP-group 2/0/0.
<Sysname> system-view
[Sysname] interface mp-group 2/0/0
[Sysname-MP-group2/0/0] ppp mp lfi size-per-frag 80
Related commands
ppp mp lfi enable
ppp mp lfi delay-per-frag

ppp mp max-bind

Use ppp mp max-bind to set the maximum number of PPP links in an MP bundle on an interface.
Use undo ppp mp max-bind to restore the default.
Syntax
ppp mp max-bind max-bind-num
undo ppp mp max-bind
Default
The maximum number of PPP links in an MP bundle is 16 on an interface.
Views
VT interface view
Dialer interface view
MP-group interface view
Predefined user roles
network-admin
Parameters
max-bind-num: Specifies the maximum number of PPP links in an MP bundle, in the range of 1 to
128.
Usage guidelines
IMPORTANT:
Use the default setting in most situations. Inappropriate use of this command can cause PPP
performance degradation. Make sure you understand the impact of this command on your network
before you use it.
Set the maximum number of PPP links in an MP bundle to be greater than the actual number of
bound links. Otherwise, MP binding fails.
The maximum number of PPP links configured for an MP bundle takes effect immediately. If the
configured maximum number is smaller than the number of existing PPP links, the existing links are
not affected.
Examples
# Set the maximum number of PPP links in an MP bundle to 12 on MP-group 2/0/0.
<Sysname> system-view
[Sysname] interface mp-group 2/0/0
[Sysname-MP-group2/0/0] ppp mp max-bind 12
53