Power-Source - H3C MSR810 Command Reference Manual

[Sysname-Bri2/4/0] isdn protocol-mode network
[Sysname-Bri2/4/0] permanent-active
Related commands
isdn protocol-mode
isdn q921-permanent

power-source

Use power-source to enable a BRI interface to supply line power to the terminal equipment.
Use undo power-source to disable a BRI interface from supplying line power to the terminal
equipment.
Syntax
power-source
undo power-source
Default
A BRI interface does not supply line power to the terminal equipment.
Views
ISDN BRI interface view
Predefined user roles
network-admin
Usage guidelines
You can configure only network-side BRI interfaces to supply line power to the terminal equipment.
Only ISDN BRI interfaces on the BSV module can operate on the network side.
You can configure the command only when no call is present.
Examples
# Configure BRI 2/4/0 to supply line power to the terminal equipment.
<Sysname> system-view
[Sysname] interface bri 2/4/0
[Sysname-Bri2/4/0] isdn protocol-mode network
[Sysname-Bri2/4/0] power-source
Related commands
isdn protocol-mode
193