Sim Switch-To - H3C MSR810 Command Reference Manual

Views
Cellular interface view
Predefined user roles
network-admin
Parameters
time: Specifies the length of time for using the secondary SIM card. The value is in the range of 1 to
65535, in minutes. The default value is 60. After the time expires, the device automatically switches
back to the primary SIM card.
Usage guidelines
IMPORTANT:
This command is supported only on MSR810-LMS/810-LUS routers and routers installed with
SIC-4G-CNDE interface modules.
This command allows the device to automatically switch back to the primary SIM card after the
specified length of time of using the secondary SIM card. To avoid frequent primary/secondary
switchovers, make sure the link of the primary SIM card can recover after the specified length of
time.
Examples
# Enable the device to automatically switch back to the primary SIM card after 100 minutes of using
the secondary SIM card.
<Sysname> system-view
[Sysname] controller cellular 0/0
[Sysname-Cellular0/0] sim switch-back enable wait-time 100

sim switch-to

Use sim switch-to to specify the primary or secondary SIM card.
Syntax
sim switch-to card-number
Default
The primary SIM card is used.
Views
Cellular interface view
Predefined user roles
network-admin
Parameters
card-number: Specifies a SIM card by its slot number. The value is 0 or 1. 0 represents the primary
SIM card. 1 represents the secondary SIM card.
Usage guidelines
CAUTION:
This command might cause traffic interruption. Be aware of the impact of this command before
executing it.
264