H3C MSR810 Command Reference Manual page 113

Field
Last 300 seconds input rate: 0 bytes/sec, 0
bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec,
0 bits/sec, 0 packets/sec
Input: 154 packets, 1880 bytes, 0 drops
Output: 155 packets, 1875 bytes, 0 drops
# Display summary information about Virtual-PPP 10.
<Sysname> display interface virtual-ppp 10 brief
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
VPPP10
# Display information about the virtual PPP interfaces in physically down state and the causes.
<Sysname> display interface virtual-ppp brief down
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Interface
VPPP9
VPPP10
VPPP12
# Display summary information about Virtual-PPP 10, including the complete interface description.
<Sysname> display inter Virtual-PPP 10 brief description
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
VPPP10
Table 18 Command output
Field
The brief information of
interface(s) under route
mode/Brief information on
interfaces in route mode
Link: ADM - administratively
down; Stby - standby
Description
Average rate of inbound traffic in the last 300 seconds.
Average rate of outbound traffic in the last 300 seconds.
Total number of inbound packets, total number of inbound
bytes, and total number of dropped inbound packets.
Total number of outbound packets, total number of outbound
bytes, and total number of dropped outbound packets.
Link Protocol Primary IP
ADM DOWN 10.0.0.1
Link Cause
ADM Administratively
ADM Administratively
ADM Administratively
Link Protocol Primary IP
ADM DOWN 10.0.0.1
Description
Summary information about Layer 3 interfaces.
Link status:
• ADM—The interface has been shut down by the network
administrator. To recover its physical layer state, execute the undo
shutdown command.
• Stby—The interface is a backup interface. To see the primary
interface, use the display interface-backup state command
described in High Availability Command Reference.
101
Description
Virtual-PPP10 Interface
Description
Virtual-PPP10 Interface