Fr Ipv6 Ind Holdtime - H3C MSR810 Command Reference Manual

undo fr map ipv6 { ipv6-address | default } dlci-number
Default
No static address-to-DLCI maps exist.
Views
Interface view (main interface view or P2MP subinterface view)
Predefined user roles
network-admin
Parameters
ip-address: Specifies the peer IPv4 address.
ipv6-address: Specifies the peer IPv6 address.
default: Creates a default address-to-DLCI map.
dlci-number: Specifies the local VC by its DLCI in the range of 16 to 1007. DLCIs 0 through 5 and
1008 through 1023 are reserved.
Usage guidelines
An address-to-DLCI map can be created automatically by using InARP or IND, or created manually.
• InARP or IND is suitable for a complex network where the peer devices also support InARP or
IND.
• As a best practice, create address-to-DLCI maps manually when the number of peer hosts is
small or when default routes exist.
The IPv4 or IPv6 address in an address-to-DLCI map must be a valid unicast IPv4 or IPv6 address.
When the VC specified in this command does not exist, the VC is automatically created.
Up to one default address-to-DLCI map can be configured on one interface.
Only one address-to-DLCI map can be configured for one IPv4 or IPv6 address on one interface.
Examples
# Create a static address-to-DLCI map on interface Serial 2/1/0 to map the VC with DLCI 50 to the
peer IP address 202.38.163.252.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] fr map ip 202.38.163.252 50
Related commands
display fr map

fr ipv6 ind holdtime

Use fr ipv6 ind holdtime to set the IND request interval during the IND learning process.
Use undo fr ipv6 ind holdtime to restore the default.
Syntax
fr ipv6 ind holdtime seconds
undo fr ipv6 ind holdtime
Default
The IND request interval during the IND learning process is 30 seconds.
348