H3C MSR810 Command Reference Manual page 289

Last link flapping: Never
Last clearing of counters: Never
Last 300 seconds input rate 0.00 bytes/sec, 0.00 packets/sec
Last 300 seconds output rate 0.00 bytes/sec, 0.00 packets/sec
Input: 0 packets, 0 bytes, 0 buffers
Output:0 packets, 0 bytes
# Display brief information about Eth-channel 2/4/0:0.
<Sysname> display interface eth-channel 2/4/0:0 brief
Brief information on interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
Echannel2/4/0:0
# Display information about all Eth-channel interfaces in down state and the causes.
<Sysname> display interface eth-channel brief down
Brief information on interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface
Echannel2/4/0:0
Table 56 Command output
Field
Current state
Line protocol state
Description
Bandwidth
Maximum Transmit Unit
Internet protocol processing:
disabled
Internet Address is
192.168.1.200/24 Primary
IP Packet Frame Type
Hardware Address
IPv6 Packet Frame Type
Link Protocol Main IP
UP UP(s) 192.168.80.239
Link Cause
ADM Administratively
Description
Physical and administrative state of the Eth-channel interface:
• Administratively DOWN—The interface has been shut down
by using the shutdown command.
• DOWN—The interface is administratively up but physically
down because no physical link is present or the link has failed.
• UP—The interface is both administratively and physically up.
Data link layer protocol state of the interface:
•
UP.
•
DOWN.
• UP(spoofing)—The data link layer protocol state of the
interface is up but the link is an on-demand link or not present at
all.
Description for the interface.
Expected bandwidth of the interface.
MTU of the interface.
IP packet processing is disabled.
Primary IP address of the interface, which is assigned automatically
by the service provider.
IPv4 packet framing format.
MAC address of the interface.
IPv6 packet framing format.
277
Description