H3C MSR810 Command Reference Manual page 174

SPID Num: 326
Neg State: SPID_UNASSIGNED
Init State: INIT_NULL
SPID timer: 30 seconds
SPID resend: 1 times
# Display SPID information for NI-enabled interface BRI 2/4/0 (the SPID type is STATIC).
<Sysname> display isdn spid interface bri 2/4/0
Interface Bri2/4/0:
SPID Type: STATIC
SPID B1:
SPID Num: 134
LDN: 3251
Init State: INIT_NULL
SPID B2:
SPID Num: 257
LDN: 3657
Init State: INIT_NULL
SPID timer: 30 seconds
SPID resend: 1 times
# Display SPID information on NI-enabled interface BRI 2/4/0 (the SPID type is NIT).
<Sysname> display isdn spid interface bri 2/4/0
Interface Bri2/4/0:
SPID Type: NIT
Table 29 Command output
Field Description
SPID assignment type:
•
SPID Type
•
•
SPID B1 SPID information for the B1 channel on the BRI interface.
SPID B2 SPID information for the B2 channel on the BRI interface.
SPID value. It is manually configured or dynamically obtained from the service
SPID Num
provider, depending on the SPID assignment type.
Local dialing number. You must configure an LDN depending on the service provider
LDN
requirement.
NIT—Not initial terminal mode. You must enable NIT mode on the BRI interface if
the NI-type service provider switch does not support SPID negotiation.
STATIC—Static SPID assignment. You must manually configure the SPIDs
assigned by the service provider on the BRI interface.
AUTO—Dynamic SPID assignment. The interface obtains SPIDs dynamically
from the service provider switch.
162