Shutdown - H3C MSR810 Command Reference Manual

Parameters
output-pcr: Specifies the peak output rate of ATM cells in kbps. For more information about the value
range, see Table
output-scr: Specifies the sustainable output rate of ATM cells in kbps. Its value ranges are the same
as those of the output-pcr argument, and i ts value is equal to or smaller than the value of
the output-pcr argument.
output-mbs: Specifies the maximum burst size of ATM cells (maximum number of ATM cells that the
output interface can cache). The value range for this argument is 1 to 512.
Usage guidelines
You can use this command as well as the service cbr, service ubr, and service vbr-nrt commands
to set the service type and parameters of a PVC. If you execute this command multiple times, the
most recent configuration takes effect.
Examples
# Create a PVC named aa on the interface ATM 2/4/0, and set the VPI/VCI, service
type, output-pcr, output-scr, and output-mbs to 1/101, VBR-RT, 100000, 50000, and 320,
respectively.
<Sysname> system-view
[Sysname] interface atm 2/4/0
[Sysname-ATM2/4/0] pvc aa 1/101
[Sysname-ATM2/4/0-pvc-aa-1/101] service vbr-rt 100000 50000 320
# Create a PVC named aa in PVC-group 1, and set the VPI/VCI, service type, output-pcr, output-scr,
and output-mbs to 1/101, VBR-RT, 100000, 50000, and 320, respectively.
<Sysname> system-view
[Sysname] interface atm 2/4/0
[Sysname-ATM2/4/0] pvc-group 1
[Sysname-ATM2/4/0-pvc-group-1] pvc aa 1/101
[Sysname-ATM2/4/0-pvc-group-1-pvc-aa-1/101] service vbr-rt 100000 50000 320
Related commands
service cbr
service ubr
service vbr-nrt

shutdown

Use shutdown to shut down an interface.
Use undo shutdown to bring up an interface.
Syntax
shutdown
undo shutdown
Default
An interface is up.
Views
VE interface view
VE subinterface view
47.
227