Fr Lmi N392Dce; Fr Lmi N392Dte - H3C MSR810 Command Reference Manual

<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] link-protocol fr
[Sysname-Serial2/1/0] fr interface-type dte
[Sysname-Serial2/1/0] fr lmi n391dte 10

fr lmi n392dce

Use fr lmi n392dce to set the DCE-side N392 counter.
Use undo fr lmi n392dce to restore the default.
Syntax
fr lmi n392dce n392-value
undo fr lmi n392dce
Default
The DCE-side N392 counter is 3.
Views
Interface view
Predefined user roles
network-admin
Parameters
n392-value: Sets the DCE-side N392 counter in the range of 1 to 10.
Usage guidelines
This command is available on DCE interfaces.
A DCE requires a DTE to send a status enquiry message at an interval set by the T392 timer. If the
DCE has not received a status enquiry message when the T392 timer expires, the error counter on
the DCE increments by one.
The N392 counter sets an error threshold for the total number of monitored events set by the N393
counter. If the number of errors during N393 events reaches N392, the DCE considers the physical
link and all VCs unavailable and will not use them to forward packets.
N392 must be less than N393 on the DCE side.
Examples
# Set the type of Frame Relay interface Serial 2/1/0 to DCE. Set N392 to 5 and N393 to 6.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] link-protocol fr
[Sysname-Serial2/1/0] fr interface-type dce
[Sysname-Serial2/1/0] fr lmi n392dce 5
[Sysname-Serial2/1/0] fr lmi n393dce 6

fr lmi n392dte

Use fr lmi n392dte to set the DTE-side N392 counter.
Use undo fr lmi n392dte to restore the default.
343