H3C MSR810 Command Reference Manual page 112

Line protocol state: DOWN
Description: Virtual-PPP10 Interface
Bandwidth: 100000kbps
Maximum transmission unit:1500
Hold timer: 10 seconds, retry times: 5
Internet address: 10.1.1.1/24 (primary)
Link layer protocol: PPP
LCP: initial
Physical: L2TP, baudrate: 100000000 bps
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 154 packets, 1880 bytes, 0 drops
Output: 155 packets, 1875 bytes, 0 drops
Table 17 Command output
Field
Current state
Line protocol state
Bandwidth
Hold timer
retry times
Internet Address
Link layer protocol
Physical
baudrate
Last clearing of counters
Description
Physical state and administrative state of the virtual PPP
interface:
• Administratively DOWN—The interface is
administratively shut down by using the shutdown
command.
• DOWN—The interface is administratively up but
physically down.
• UP—The interface is up both administratively and
physically.
Link layer protocol state of the virtual PPP interface:
• UP—The interface is up at the data link layer.
• UP (spoofing)—The link layer protocol of an interface is
UP, but its link is an on-demand link or not present at all.
• DOWN—The interface is down at the data link layer.
Intended bandwidth of the interface.
Interval in seconds for the interface to send keepalive packets.
Keepalive retry limit.
The interface determines that its peer has been down if it does
not receive a keepalive response when the keepalive retry limit
is reached.
IP address of the interface:
• Internet protocol processing: disabled—No IP address
is configured, and the interface cannot process IP
packets.
• Primary—The IP address is the primary one of the
interface.
Link layer protocol of the interface: PPP.
Physical type of the interface: L2TP.
Baud rate of the interface.
Time when the reset counters interface command was last
used to clear the interface statistics. This field displays Never if
the reset counters interface command has never been used
on the interface since device startup.
100