Dialer Number - H3C MSR810 Command Reference Manual

Usage guidelines
DDR provides traffic statistics for dialup links at the user-configured interval.
Examples
# Set the interval for DDR to collect traffic statistics to 3 seconds.
<Sysname> system-view
[Sysname] dialer flow-interval 3
Related commands
dialer threshold

dialer number

Use dialer number to configure a dial string for placing calls to a single remote site.
Use undo dialer number to restore the default.
Syntax
dialer number dial-number [ autodial ]
undo dialer number
Default
No dial string is configured for calling the remote site.
Views
Dialup interface view
Predefined user roles
network-admin
Parameters
dial-number: Specifies a d ial string for calling a r emote site, a case-insensitive string of 1 t o 30
characters.
autodial: Enables the interface to automatically dial the remote site by using the specified dial string
at specified intervals. The interval is set in the dialer timer autodial command and defaults to 300
seconds.
Usage guidelines
You must configure this command when the dialer or physical interface is the calling party.
In traditional DDR, you can also use the dialer route command to configure multiple destination
addresses or dial strings for a dialer interface.
In bundle DDR, you can only use the dialer number command to configure one dial string for each
dialer interface. This is because associations between dialer interfaces and call destination address
are one-to-one.
Examples
# Set the dial string for placing calls to 11111 on Dialer 1.
<Sysname> system-view
[Sysname] interface dialer 1
[Sysname-Dialer1] dialer number 11111
Related commands
dialer route
294