Reset Pppoe-Client - H3C MSR810 Command Reference Manual

Syntax
pppoe-client dial-bundle-number number [ no-hostuniq ]
undo pppoe-client dial-bundle-number number
Default
No PPPoE session is established.
Views
Layer 3 Ethernet interface/subinterface view
Layer 3 virtual Ethernet interface/subinterface view
VLAN interface view
Predefined user roles
network-admin
Parameters
dial-bundle-number number: Specifies the dialer bundle number corresponding to a P PPoE
session, in the range of 0 to 1023. A dialer bundle number uniquely identifies a PPPoE session. It
can also be used as a PPPoE session ID.
no-hostuniq: Configures the client not to carry the Host-Uniq field in discovery packets. If you do not
specify this keyword, the client carries the Host-Unique field. The Host-Unique field uniquely
identifies a PPPoE client when an interface is configured with multiple PPPoE sessions. When the
PPPoE server receives a packet with this field, it must include this field unmodified in the response
packet. The device identifies the PPPoE client where the response packet belongs based on the
Host-Unique field in the response packet.
Examples
# Establish a PPPoE session on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] pppoe-client dial-bundle-number 1
# Establish a PPPoE session on Virtual-Ethernet 0.
<Sysname> system-view
[Sysname] interface virtual-ethernet 0
[Sysname-Virtual-Ethernet0] pppoe-client dial-bundle-number 1
# Establish a PPPoE session on VLAN-Interface 1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] pppoe-client dial-bundle-number 1

reset pppoe-client

Use reset pppoe-client to reset a PPPoE session corresponding to a dialer bundle.
Syntax
reset pppoe-client { all | dial-bundle-number number }
Views
User view
Predefined user roles
network-admin
94