H3C MSR810 Command Reference Manual page 319

Examples
# Display detailed information about Dialer 1.
<Sysname> display interface dialer 1
Dialer1
Current state: UP
Line protocol state: UP (spoofing)
Description: Dialer1 Interface
Bandwidth: 64kbps
Maximum Transmit Unit: 1500
Hold timer: 10 seconds, retry times: 5
Internet protocol processing: disabled
Link layer protocol: PPP
LCP: initial
Physical: Dialer, baudrate: 64000 bps
Output queue - Urgent queuing: Size/Length/Discards 0/100/0
Output queue - Protocol queuing: Size/Length/Discards 0/500/0
Output queue - FIFO queuing: Size/Length/Discards 0/75/0
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 dropped
Output: 0 packets, 0 bytes, 0 dropped
# Display brief information about Dialer 1.
<Sysname> display interface dialer 1 brief
Brief information on interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
Dia1
# Display brief information about all dialer interfaces in physically Down state.
<Sysname> display interface dialer brief down
Brief information on interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface
Dia1
Table 58 Command output
Field
Dialer1
Current state
Line protocol state
Description
Bandwidth
Maximum Transmit Unit
Link Protocol Main IP
UP UP(s) --
Link Cause
ADM Administratively
Description
Physical state of the dialer interface:
• UP—The dialer interface is physically up.
• DOWN (Administratively)—The dialer interface was shut down by
using the shutdown command. To re-enable it, you must execute
the undo shutdown command.
Data link layer protocol state of the dialer interface: UP or DOWN.
Interface description.
Expected bandwidth of the interface.
MTU of the dialer interface.
307
Description