L2Tp Enable; L2Tp Tsa-Id - H3C MSR810 Command Reference Manual

[Sysname] l2tp-group 1 mode lac
[Sysname-l2tp1] ip dscp 50

l2tp enable

Use l2tp enable to enable L2TP.
Use undo l2tp enable to disable L2TP.
Syntax
l2tp enable
undo l2tp enable
Default
L2TP is disabled.
Views
System view
Predefined user roles
network-admin
Usage guidelines
For L2TP configurations to take effect, you must enable L2TP.
Examples
# Enable L2TP.
<Sysname> system-view
[Sysname] l2tp enable

l2tp tsa-id

Use l2tp tsa-id to set the TSA ID for the L2TP tunnel switching (LTS) device and enable L2TP loop
detection on the LTS device.
Use undo l2tp tsa-id to restore the default.
Syntax
l2tp tsa-id tsa-id
undo l2tp tsa-id
Default
The TSA ID of the LTS device is not set, and L2TP loop detection is disabled on the LTS device.
Views
System view
Predefined user roles
network-admin
Parameters
tsa-id: Specifies a TSA ID that uniquely identifies the LTS device. This argument is a case-sensitive
string of 1 to 64 characters.
107