Dialer Call-In - H3C MSR810 Command Reference Manual

Views
Dialup interface view
Predefined user roles
network-admin
Parameters
dial-number:
callback-number command in local user view to place return calls.
user: Uses the dial string configured in the dialer route command to place return calls.
Usage guidelines
This command is mandatory on the PPP callback server.
If both the dial-number and user keywords are specified, the device attempts to place return calls
by using the dial string determined by the first keyword entered. If the attempt fails, the device places
return calls by using the dial string determined by the second keyword entered.
If the command is configured with neither keyword, it has the same effect as the dialer
callback-center user dial-number command.
Examples
# Specify the device as the PPP callback server, and set the callback reference to user mode.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] ppp callback server
[Sysname-Serial2/1/0] dialer callback-center user
[Sysname-Serial2/1/0] dialer route ip 1.1.1.2 8810052 user Sysnameb
# Specify the device as the PPP callback server, and set the callback reference to dial number mode.
<Sysname> system-view
[Sysname] local-user usera
[Sysname-luser-usera] password simple usera
[Sysname-luser-usera] service-type ppp
[Sysname-luser-usera] authorization-attribute callback-number 8810048
[Sysname-luser-usera] quit
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] ppp callback server
[Sysname-Serial2/1/0] dialer callback-center dial-number
Related commands
ppp callback

dialer call-in

Use dialer call-in to configure a dialup interface to accept incoming calls from an I SDN calling
number or enable callback for the ISDN calling number.
Use undo dialer call-in to restore the default.
Syntax
dialer call-in remote-number [ callback ]
undo dialer call-in remote-number [ callback ]
Uses the callback number configured
290
in the
authorization-attribute