H3C MSR810 Command Reference Manual page 53

Field
retry times
Internet protocol processing: Disabled
Internet address: 122.1.1.1/24
(primary)
LCP: opened, MP: opened, IPCP:
opened
Physical
Main interface
Output queue - Urgent queuing:
Size/Length/Discards 0/100/0
Output queue - Protocol queuing:
Size/Length/Discards 0/500/0
Output queue - FIFO queuing:
Size/Length/Discards 0/75/0
Last clearing of counters: Never
Last 300 seconds input rate: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0
bytes/sec, 0 bits/sec, 0 packets/sec
Input: 2 packets, 24 bytes, 0 drops
Output: 2 packets, 24 bytes, 0 drops
Brief information on interfaces in route
mode
Link: ADM - administratively down;
Stby - standby
Protocol: (s) - spoofing
Interface
Link
Description
Keepalive retry limit.
The interface determines that its peer has been down if it does not
receive a keepalive response when the keepalive retry limit is
reached.
The interface cannot process IP packets currently.
Primary IP address of the interface.
The PPP connection has been successfully established.
Physical type of the interface.
VT interface associated with the VA interface.
Traffic statistics of the interface output queues.
Last time when statistics on the interface were cleared. Never
indicates that statistics on the interface were never cleared.
Average rate of input packets and output packets in the last 300
seconds.
Total number of inbound packets of the interface (in the number of
packets and in bytes), and the number of packets dropped among
the inbound packets.
Total number of outbound packets of the interface (in the number of
packets and in bytes), and the number of packets dropped among
the outbound packets.
Brief information about Layer 3 interfaces.
Link status:
• ADM—The interface has been administratively shut down. To
recover its physical state, execute the undo shutdown
command.
• Stby—The interface is a backup interface. To see the primary
interface, use the display interface-backup state command
in High Availability Command Reference.
Indicates the line protocol is UP, but the physical link is an
on-demand link or is not present.
Abbreviated interface name.
Physical link state of the interface:
• UP—The interface is physically up.
• DOWN—The interface is physically down.
41