Ppp Mp Endpoint - H3C MSR810 Command Reference Manual

Default
Both the username and the descriptor are used for MP binding on an interface.
Views
VT interface view
Dialer interface view
Predefined user roles
network-admin
Parameters
authentication: Uses the username for MP binding.
both: Uses both the username and the endpoint descriptor for MP binding.
descriptor: Uses the endpoint descriptor for MP binding.
Usage guidelines
The username is obtained from the peer during PAP, CHAP, MS-CHAP, or MS-CHAP-V2
authentication. The endpoint descriptor, which uniquely identifies a device, is obtained from the peer
during LCP negotiation. Based on the username or endpoint descriptor, the system can locate the
corresponding VT interface and create an MP bundle according to the template.
The descriptor mode cannot differentiate users. To bind users to different bundles, use the both
mode.
The authentication mode cannot differentiate peer devices. When multiple peer devices exist, use
the both mode.
Examples
# Specify Virtual-Template 1 to use the username for MP binding.
<Sysname> system-view
[Sysname] interface virtual-template1
[Sysname-Virtual-Template1] ppp mp binding-mode authentication

ppp mp endpoint

Use ppp mp endpoint to set the endpoint option.
Use undo ppp mp endpoint to restore the default.
Syntax
ppp mp endpoint endpoint
undo ppp mp endpoint
Default
The endpoint option carries the device name on an interface.
Views
Interface view
Predefined user roles
network-admin
Parameters
endpoint: Specifies the content of the endpoint option, a case-sensitive string of 1 to 20 characters.
49