H3C MSR810 Command Reference Manual page 50

Field
Hold timer
retry times
Internet protocol processing
Internet address: 192.168.1.200/24
(primary)
LCP initial
Physical
baudrate
Output queue - Urgent queuing:
Size/Length/Discards 0/100/0
Output queue - Protocol queuing:
Size/Length/Discards 0/500/0
Output queue - FIFO queuing:
Size/Length/Discards 0/75/0
Last clearing of counters: Never
Last 300 seconds input rate: 0
bytes/sec, 0 packets/sec
Last 300 seconds output rate: 0
bytes/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
Brief information on interfaces in route
mode
Link: ADM - administratively down;
Stby - standby
Protocol: (s) - spoofing
Interface
Link
Description
Interval at which the interface sends keepalive packets.
Keepalive retry limit.
The interface determines that its peer has been down if it does not
receive a keepalive response when the keepalive retry limit is
reached.
The interface cannot process IP packets currently.
Primary IP address of the interface.
LCP negotiation is complete.
Physical type of the interface.
Baud rate of the interface.
Traffic statistics of the interface output queues.
Last time when statistics on the interface were cleared. Never
indicates that statistics on the interface were never cleared.
Average rate of input packets and output packets in the last 300
seconds.
Total number of inbound packets of the interface (in the number of
packets and in bytes), and the number of dropped incoming
packets.
Total number of outbound packets of the interface (in the number of
packets and in bytes), and the number of dropped outgoing
packets.
Brief information about Layer 3 interfaces.
Link status:
• ADM—The interface has been administratively shut down. To
recover its physical state, execute the undo shutdown
command.
• Stby—The interface is operating as a backup interface. To
see the primary interface, use the display interface-backup
state command in High Availability Command Reference.
Indicates the line protocol is UP, but the physical link is an
on-demand link or is not present.
Abbreviated interface name.
Physical link state of the interface:
• UP—The interface is physically up.
• DOWN—The interface is physically down.
• ADM—The interface has been administratively shut down. To
recover its physical state, use the undo shutdown command.
• Stby—The interface is a backup interface.
38