H3C MSR810 Command Reference Manual page 159

Field
Last 300 seconds input rate: 0
bytes/sec, 0 bits/sec, 0
packets/sec
Last 300 seconds output rate: 0
bytes/sec, 0 bits/sec, 0
packets/sec
Input: 32 packets, 1842 bytes, 0
drops
Output: 27 packets, 1512 bytes, 0
drops
Brief information on interface(s)
under route mode
Link: ADM - administratively down;
Stby - standby
Protocol: (s) – spoofing
Interface
Link
Protocol
Main IP
Description
Cause
Related commands
reset counters interface
Description
Average incoming and outgoing traffic rates on the interface in the last
300 seconds.
Incoming traffic size in packets and bytes and the number of dropped
incoming packets on the interface.
Outgoing traffic size in packets and bytes and the number of dropped
outgoing packets on the interface.
Brief information about Layer 3 interfaces.
Link status:
• ADM—The interface has been administratively shut down. To
recover its physical state, perform the undo shutdown
command.
• Stby—The interface is operating as a backup interface. To see
the primary interface, use the display interface-backup state
command.
If the data link layer protocol state of an interface is shown as UP, but
its link is an on-demand link or not present at all, the protocol attribute
includes the spoofing flag (an s in parentheses).
Abbreviated interface name.
Physical link state of the interface:
• UP—The interface is up.
• ADM—The interface has been administratively shut down. To
bring up the interface, perform the undo shutdown command.
Date link layer protocol state of the interface:
• UP—The data link layer protocol state of the interface is up.
• DOWN—The data link layer protocol state of the interface is
down.
• UP(s)—The data link layer protocol state of the interface is shown
as UP, but its link is an on-demand link or not present at all.
Main IP address of the interface. Two hyphens (--) indicate that no
main IP address is configured for the interface.
Partial or complete interface description configured by using
the description command:
• If the description keyword is not specified for the display
interface brief command, this field displays only the first 27
characters of the interface description.
• If the description keyword is specified for the display interface
brief command, this field displays the complete interface
description.
Reason why a physical link is down. If the port has been shut down by
using the shutdown command, this field displays Administratively.
To restore the physical state of the interface, use the undo shutdown
command.
147