Eth-Channel - H3C MSR810 Command Reference Manual

Field
Link: ADM - administratively down;
Stby - standby
Protocol: (s) - spoofing
Interface
Link
Protocol
Main IP
Description
Cause

eth-channel

Use eth-channel to channelize a cellular interface into an Eth-channel interface.
Use undo eth-channel to remove the Eth-channel interface channelized from a cellular interface.
Syntax
eth-channel channel-number
undo eth-channel channel-number
Views
Cellular interface view
Predefined user roles
network-admin
Description
Explains the Link field values:
• ADM—The interface has been shut down by the network
administrator. To recover its physical layer state, execute the
undo shutdown command.
• Stby—The interface is a standby interface. To view the primary
interface information, execute the display interface-backup
state command.
Explains the Protocol field value.
(s) represents spoofing. If the data link layer protocol of an interface
is up but its link is an on-demand link or not present at all, the
Protocol field displays UP(s).
Interface name.
Physical state of the interface:
• UP—The interface is up.
• DOWN—The interface is physically down.
• ADM—The interface has been administratively shut down. To
recover its physical state, execute the undo shutdown
command.
• Stby—The interface is a standby interface.
Data link layer protocol state of the interface:
•
UP.
•
DOWN.
• UP(s)—The data link layer protocol state of the interface is up
but the link is an on-demand link or not present at all.
Main IP address of the interface.
Interface description configured by using the description command.
If the description keyword is not specified in the display interface
brief command, the Description field displays the first 27 characters
of the interface description. If the description keyword is specified in
the display interface brief command, this field displays the
complete interface description.
Cause of the interface down event. If the interface has been shut
down by using the shutdown command, this field displays
Administratively. To restore the physical state of the interface,
execute the undo shutdown command.
279