Modem Enable - H3C MSR810 Command Reference Manual

This command is for point of sale (POS) terminal access services. It is available only on TTY lines for
AM interfaces.
Configure this command if a bank front end processor requires the router to send the call numbers of
POS terminals for acknowledgment before it accepts data from the terminals.
For more information about POS terminal access services and caller number sending, see Terminal
Access Configuration Guide.
Examples
# Enable the modem to obtain caller numbers on TTY 81, and set the caller number waiting timer to
10 seconds.
<Sysname> system-view
[Sysname] line tty 81
[Sysname-line-tty81] modem caller-number resolve ata-waiting-time 10000
Related commands
modem auto-answer

modem enable

Use modem enable to enable the modem to answer incoming calls, initiate outgoing calls, or both.
Use undo modem enable to disable the modem from answering incoming calls and initiating
outgoing calls .
Syntax
modem enable { both | call-in | call-out }
undo modem enable
Default
The modem is disabled from answering incoming calls and initiating outgoing calls.
Views
User line view
Predefined user roles
network-admin
Parameters
both: Enables the modem to answer incoming calls and initiate outgoing calls.
call-in: Enables the modem to answer incoming calls.
call-out: Enables the modem to initiate outgoing calls.
Usage guidelines
CAUTION:
Executing this command disconnects the modem connection that has been established on the user
line.
This command is available on the following user lines:
• TTY lines for the following interfaces:
AM interface

Asynchronous serial interface

Asynchronous/synchronous serial interface operating in asynchronous mode

235