L2Tp-Group; Lns-Ip - H3C MSR810 Command Reference Manual

Related commands

l2tp-group

l2tp-group
Use l2tp-group to create an L2TP group and enter its view, or enter the view of an existing L2TP
group.
Use undo l2tp-group to delete an L2TP group.
Syntax
l2tp-group group-number [ mode { lac | lns } ]
undo l2tp-group group-number
Default
No L2TP group exists.
Views
System view
Predefined user roles
network-admin
Parameters
group-number: Specifies an L2TP group by its number in the range of 1 to 65535.
mode: Specifies a mode for the L2TP group.
lac: Specifies the LAC mode.
lns: Specifies the LNS mode.
Usage guidelines
To create a new L2TP group, you must specify the mode keyword. To enter the view of an existing
L2TP group, you do not need to specify this keyword.
In L2TP group view, you can configure L2TP tunnel parameters, such as tunnel authentication and
flow control.
A device can have L2TP groups in both LAC and LNS modes at the same time. A device can have a
maximum number of 32768 L2TP groups.
Examples
# Create L2TP group 2 in LAC mode, and enter its view.
<Sysname> system-view
[Sysname] l2tp-group 2 mode lac
[Sysname-l2tp2]
Related commands
allow l2tp

lns-ip

user
lns-ip
Use lns-ip to specify LNS IP addresses on an LAC.
110