H3C MSR810 Command Reference Manual page 55

Current state: DOWN
Line protocol state: DOWN
Description: Virtual-Template1 Interface
Bandwidth: 100000kbps
Maximum transmission unit: 1500
Hold timer: 10 seconds, retry times: 5
Internet address: 192.168.1.200/24 (primary)
Link layer protocol: PPP
LCP: initial
Physical: None, baudrate: 100000000 bps
Output queue - Urgent queuing: Size/Length/Discards 0/100/0
Output queue - Protocol queuing: Size/Length/Discards 0/500/0
Output queue - FIFO queuing: Size/Length/Discards 0/75/0
# Display brief information about Virtual-Template 1.
<Sysname> display interface virtual-template 1 brief
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
VT1
# Display brief information about the VT interfaces in physically down state and the causes.
<Sysname> display interface Virtual-Template brief down
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Interface
VT0
VT12
VT1023
Table 8 Command output
Field
Current state
Line protocol state
Description
Bandwidth
Hold timer
retry times
Internet protocol processing: Disabled
Internet address: 192.168.1.200/24
(primary)
LCP initial
Link Protocol Primary IP
DOWN DOWN --
Link Cause
DOWN Not connected
DOWN Not connected
DOWN Not connected
Description
Physical state of the interface. This field for a VT interface can only
be DOWN.
Data link layer state. This field for a VT interface can only
be DOWN.
Interface description.
Expected bandwidth of the interface.
Interval at which the interface sends keepalive packets.
Keepalive retry limit.
The interface determines that its peer has been down if it does not
receive a keepalive response when the keepalive retry limit is
reached.
The interface cannot process IP packets currently.
Primary IP address of the interface.
LCP initialization is complete.
43
Description