H3C MSR810 Command Reference Manual page 213

Msr router series comware 7 layer 2 - wan access
Hide thumbs Also See for MSR810:
Table of Contents

Advertisement

Field
Precedence
Service-type
Output-pcr
CDVT
Transmit-Priority
OAM loopback interval
OAM loopback retry interval
OAM loopback retry count (up/down)
OAM AIS-RDI count (up/down)
Interface State
OAM State
Description
Priority of the IP packets carried by the PVC in the PVC-group:
Default—Default PVC. IP packets without a priority configured
are transmitted through the default PVC.
a-b—Lowest and highest priorities of the IP packets carried by
the PVC. The value range for a and b is 0 to 7. a is smaller
than b.
c—Priority of the IP packets carried by the PVC, in the range of
0 to 7.
-—No priority is configured for IP packets carried by the PVC.
Service type:
CBR—Constant bit rate.
UBR—Unspecified bit rate.
VBR-NRT—Variable bit rate-non real time.
VBR-RT—Variable bit rate-real time.
Peak output rate of ATM cells.
Cell delay variation tolerance in microseconds.
Transmission priority.
Interval (in seconds) at which OAM F5 Loopback cells are sent.
Interval (in seconds) at which OAM F5 Loopback retransmission
detection cells are sent.
Number of cells that are detected as up and down in OAM detection.
Number of seconds that are detected as up in OAM AIS-RDI
detection. Number of cells that are detected as down in OAM
AIS-RDI detection.
Name of the interface to which the PVC belongs, and the physical
and administrative states of the interface.
State of an interface (not a subinterface):
UP—The interface is both physically and administratively up.
DOWN—The interface is in either of the following states:
The interface is administratively up and physically down
(probably because no physical link is available or the link
has failed).
The interface is administratively down (shut down by using
the shutdown command).
State of a subinterface:
UP—The interface is administratively up. The parent interface
is both physically and administratively up.
DOWN—The interface or its parent interface was shut down by
using the shutdown command, or the parent interface is
physically down.
OAM protocol state: UP or DOWN.
201

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents