H3C MSR810 Command Reference Manual page 52

Examples
# Display information about Virtual-Access 1.
<Sysname> display interface virtual-access 1
Virtual-Access1
Current state: UP
Line protocol state: UP
Description: Virtual-Access1 Interface
Bandwidth: 1920kbps
Maximum transmission unit: 1500
Hold timer: 10 seconds, retry times: 5
Internet address: 122.1.1.1/24 (primary)
Link layer protocol: PPP
LCP: opened, MP: opened, IPCP: opened
Physical: MP, baudrate: 1920000 bps
Main interface: Virtual-Template1
Output queue - Urgent queuing: Size/Length/Discards 0/100/0
Output queue - Protocol queuing: Size/Length/Discards 0/500/0
Output queue - FIFO queuing: Size/Length/Discards 0/75/0
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 2 packets, 24 bytes, 0 drops
Output: 2 packets, 24 bytes, 0 drops
# Display brief information about Virtual-Access 1.
<Sysname> display interface virtual-access 1 brief
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface
VA1
# Display brief information about VA interfaces in physically down state and the causes.
<Sysname> display interface virtual-access brief down
Brief information on interfaces in route mode:
Link: ADM - administratively down; Stby - standby
Interface
VA1
Table 7 Command output
Field
Current state
Line protocol state
Description
Bandwidth
Hold timer
Link Protocol Primary IP
DOWN DOWN --
Link Cause
DOWN Not connected
Description
Physical and administrative states of the interface:
• DOWN—The interface is administratively up but physically
down.
• UP—The interface is both administratively and physically up.
Data link layer state: UP or DOWN.
Interface description.
Expected bandwidth of the interface.
Interval at which the interface sends keepalive packets.
40
Description