Remote Address Dhcp Client-Identifier - H3C MSR810 Command Reference Manual

Usage guidelines
This command can be used when the local interface is configured with an IP address, but the peer
has no IP address. To enable the peer to accept the IP address assigned by the local interface
(server), you must configure the ip address ppp-negotiate command on the peer to make the peer
act as a client.
This command enables the local interface to forcibly assign an IP address to the peer. If the peer is
not configured with the ip address ppp-negotiate command but configured with an IP address, the
peer will not accept the assigned IP address. This results in an IPCP negotiation failure.
PPP supports IP address assignment from a PPP or DHCP address pool, but the PPP address pool
takes precedence over the DHCP address pool. For example, if you use a pool name that identifies
both a PPP address pool and a DHCP address pool, the system uses only the PPP address pool for
address assignment.
To make the configuration of the remote address command take effect, configure this command
before the ip address command, which triggers IPCP negotiation. If you configure the remote
address command after the ip address command, the server assigns an IP address to the client
during the next IPCP negotiation.
After you use the remote address command to assign an IP address to the client, you can configure
the remote address command again or the undo remote address command for the peer. However,
the new configuration does not take effect until the next IPCP negotiation.
Examples
# Specify the IP address to be assigned to the client as 10.0.0.1 on Serial 2/1/0.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] remote address 10.0.0.1
# Configure Serial 2/1/0 to assign an IP address from address pool aaa to the client.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] remote address pool aaa
Related commands
ip address ppp-negotiate
ip pool

remote address dhcp client-identifier

Use remote address dhcp client-identifier username to use the PPP usernames as the DHCP
client IDs.
Use undo remote address dhcp client-identifier to restore the default.
Syntax
remote address dhcp client-identifier username
undo remote address dhcp client-identifier
Default
The PPP usernames are not used as the DHCP client IDs.
Views
Interface view
30