Pppoe-Server Access-Line-Id Trust - H3C MSR810 Command Reference Manual

Views
Layer 3 Ethernet interface/subinterface view
Layer 3 virtual Ethernet interface/subinterface view
VLAN interface view
Layer 3 aggregate interface/subinterface view
VE-L3VPN interface/subinterface view
EFM interface/subinterface view
Predefined user roles
network-admin
Parameters
ascii: Specifies the character string format.
hex: Specifies the hexadecimal format.
Usage guidelines
The remote-id is the system MAC address of a PPPoE relay device (for example, DSLAM). It can be
transmitted in character strings or hexadecimal format.
Examples
# Configure GigabitEthernet 1/0/1 to use the hexadecimal format to transmit the remote-id.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] pppoe-server access-line-id remote-id trans-format hex

pppoe-server access-line-id trust

Use pppoe-server access-line-id trust to configure the PPPoE server to trust the access line ID in
received packets on an interface.
Use undo pppoe-server access-line-id trust to restore the default.
Syntax
pppoe-server access-line-id trust
undo pppoe-server access-line-id trust
Default
The PPPoE server does not trust the access line ID in received packets on an interface.
Views
Layer 3 Ethernet interface/subinterface view
Layer 3 virtual Ethernet interface/subinterface view
VLAN interface view
Layer 3 aggregate interface/subinterface view
VE-L3VPN interface/subinterface view
EFM interface/subinterface view
Predefined user roles
network-admin
79