Isdn Number-Property - H3C MSR810 Command Reference Manual

Views
ISDN BRI interface view
Predefined user roles
network-admin
Usage guidelines
The data link type of an ISDN BRI interface can be one of the following:
• point-to-point—The BRI interface can be connected only to one terminal device.
• point-to-multipoint—The BRI interface can be connected to multiple terminal devices.
Set the data link type of an ISDN BRI interface to be the same as its connected service provider
switch.
If the isdn two-tei command is configured, the data link of the BRI interface must be
point-to-multipoint.
You cannot change an ISDN BRI interface's data link type when a call is present.
Examples
# Configure BRI 2/4/0 to operate in point-to-point mode.
<Sysname> system-view
[Sysname] interface bri 2/4/0
[Sysname-Bri2/4/0] isdn link-mode p2p
Related commands
isdn two-tei

isdn number-property

Use isdn number-property to set the number type and numbering plan identification for calling or
called numbers in incoming or outgoing ISDN calls.
Use undo isdn number-property to restore the default.
Syntax
isdn number-property number-property [ calling | called ] [ in | out ]
undo isdn number-property [ calling | called ] [ in | out ]
Default
The system automatically selects a number type and numbering plan appropriate to the upper-layer
service.
Views
ISDN interface view
Predefined user roles
network-admin
Parameters
number-property: Specifies the type and numbering identification plan of ISDN numbers, a
hexadecimal string in the range of 0 to 7F. In binary form, the string contains 8 bits:
• Bits 1 through 4 represent the numbering identification plan.
• Bits 5 through 7 represent type of the number.
• Bit 8 is reserved for extension.
175