H3C MSR810 Command Reference Manual page 224

Default
No IPoA mappings for a PVC or PVC group exist.
Views
PVC view
PVC-group view
Predefined user roles
network-admin
Parameters
ip-address: Specifies the remote IP address mapped to the PVC or PVC-group.
default: Sets the default PVC mapping. If no PVC mapping can be found for the next hop address of
a packet, the packet is sent through the default PVC or PVC-group.
inarp: Enables InARP on the PVC.
minutes: Specifies the interval for sending InARP packets, in the range of 1 to 600 minutes. The
default is 15 minutes.
Usage guidelines
All encapsulations support IPoA. Only aal5snap supports InARP. You cannot configure InARP
when aal5mux or aal5nlpid is used.
A PVC or PVC-group can be configured with multiple IP address mappings, including static IP
address mapping, default mapping, and InARP mapping.
Different PVCs or PVC-groups on the same interface cannot be mapped to the same IP address.
The PVCs or PVC-groups on the same interface can be configured with only one default mapping.
If you do not specify any arguments or keywords, the undo map ip command deletes all static IP
address mappings, default mappings, and InARP mappings on the PVC or PVC-group.
This command is not applicable to PVCs in a PVC-group.
Examples
# Create a static IP address mapping on PVC 1/32, and set the IP address of the remote end to
61.123.30.169.
<Sysname> system-view
[Sysname] interface atm 2/4/0
[Sysname-ATM2/4/0] pvc 1/32
[Sysname-ATM2/4/0-pvc-1/32] map ip 61.123.30.169
# Enable InARP mapping on PVC 1/33, and set the InARP packet sending interval to 10 minutes.
<Sysname> system-view
[Sysname] interface atm 2/4/0
[Sysname-ATM2/4/0] pvc 1/33
[Sysname-ATM2/4/0-pvc-1/33] map ip inarp 10
# Delete all IP address mappings on PVC 1/33.
<Sysname> system-view
[Sysname] interface atm 2/4/0
[Sysname-ATM2/4/0] pvc 1/33
[Sysname-ATM2/4/0-pvc-1/33] undo map ip
Related commands
encapsulation
212