H3C MSR810 Command Reference Manual page 219

<Sysname> display interface virtual-ethernet brief down
Brief information on interface(s) under bridge mode:
Link: ADM - administratively down; Stby - standby
Interface
VE2/4/1
Table 44 Command output
Field
Current state
Line protocol state
Internet protocol processing
IP Packet Frame Type
IPv6 Packet Frame Type
Hardware Address
Last clearing of counters: Never
Last 300 seconds input rate
Last 300 seconds output rate
Input
Output
Brief information on interface(s)
under route mode
Link: ADM - administratively
down; Stby - standby
Protocol: (s) - spoofing
Interface
Link Cause
DOWN Not connected
Description
Physical state of the interface:
• Administratively DOWN—The interface was shut down by using
the shutdown command.
• DOWN—The interface is administratively up but physically down
(probably because no physical link is available or the link has
failed).
• UP—The interface is both administratively and physically up.
Link layer protocol state of the interface: UP or DOWN.
Internet protocol processing state of the interface.
Encapsulation format for IPv4 packets. PKTFMT_ETHNT_2 stands for
Ethernet II frame format.
Encapsulation format for IPv6 packets.
MAC address of the interface.
Time when the reset counters interface command was last used to
clear the interface statistics. Never indicates the reset counters
interface command has never been used on the interface after the
device has started up.
Average packet input rate over the last 300 seconds.
Average packet output rate over the last 300 seconds.
Input packet statistics:
• packets—Number of packets.
• bytes—Total bytes.
• drops—Number of dropped packets.
Output packet statistics:
• packets—Number of packets.
• bytes—Total bytes.
• drops—Number of dropped packets.
Brief information about the Layer 3 interface.
Link layer state of the interface:
• ADM—The interface was shut down by the network administrator.
To recover its physical layer state, use the undo shutdown
command.
• Stby—The interface is a standby interface. You can use
the display interface-backup state command to check the
corresponding primary interface.
If the protocol attribute of an interface includes the spoofing flag (an s in
parentheses), the data link layer protocol state of the interface is shown
as UP, but its link is an on-demand link or not present at all.
Abbreviation of the interface name.
207