Dialer-Group Rule - H3C MSR810 Command Reference Manual

[Sysname-Serial2/1/0] dialer-group 1
Related commands

dialer-group rule

dialer-group rule
Use dialer-group rule to create a dialer group and configure a dial rule for it.
Use undo dialer-group rule to delete a dialer group.
Syntax
dialer-group group-number rule { ip | ipv6 } { deny | permit | acl { acl-number | name acl-name } }
undo dialer-group group-number rule [ ip | ipv6 ]
Default
No dialer group exists.
Views
System view
Predefined user roles
network-admin
Parameters
group-number: Specifies the number of the dialer group to be created, in the range of 1 to 255.
ip: Specifies the IPv4 protocol.
ipv6: Specifies the IPv6 protocol.
deny: Denies packets of the specified protocol.
permit: Permits packets of the specified protocol.
acl acl-number: Specifies an ACL by its number in the range of 2000 to 3999.
name acl-name: Specifies an ACL by its name.
Usage guidelines
A dial rule determines when an interface initiates DDR calls. You need to configure dial rules only on
the initiator of DDR calls.
You can configure a dial rule to match only IP packets or use an ACL to match packets.
Permitted protocol packets or packets that match a permit statement of an ACL are interesting
packets. When receiving an interesting packet, DDR performs one of the following operations:
• Sends it out and resets the idle-timeout timer if a link is present.
• Originates a new call to establish a link if no link is present.
Denied protocol packets or packets that match a deny statement of an A CL are uninteresting
packets. When receiving an uninteresting packet, DDR performs one of the following operations:
• Sends it out without resetting the idle-timeout timer if a link is present.
• Drops it if no link is present.
For DDR to forward packets correctly, you must configure a dial rule and associate it with the dialup
interface by using the dialer-group command.
304