Fr Lmi N393Dce - H3C MSR810 Command Reference Manual

Syntax
fr lmi n392dte n392-value
undo fr lmi n392dte
Default
The DTE-side N392 counter is 3.
Views
Interface view
Predefined user roles
network-admin
Parameters
n392-value: Sets the DTE-side N392 counter in the range of 1 to 10.
Usage guidelines
This command is available on DTE interfaces.
A DTE sends a status enquiry message at an interval to a DCE to request the link status. When the
DCE receives a status enquiry message, the DCE immediately sends a status message. If the DTE
has not received the status message when the T391 timer expires, the error counter on the DTE
increments by one.
The N392 counter sets an error threshold for the total number of monitored events set by the N393
counter. If the number of errors during N393 events reaches N392, the DTE considers the physical
link and all VCs unavailable and will not use them to forward packets.
N392 must be less than N393 on the DTE side.
Examples
# Set the type of Frame Relay interface Serial 2/1/0 to DTE. Set N392 to 5 and N393 to 6.
<Sysname> system-view
[Sysname] interface serial 2/1/0
[Sysname-Serial2/1/0] link-protocol fr
[Sysname-Serial2/1/0] fr interface-type dte
[Sysname-Serial2/1/0] fr lmi n392dte 5
[Sysname-Serial2/1/0] fr lmi n393dte 6

fr lmi n393dce

Use fr lmi n393dce to set the DCE-side N393 counter.
Use undo fr lmi n393dce to restore the default.
Syntax
fr lmi n393dce n393-value
undo fr lmi n393dce
Default
The DCE-side N393 counter is 4.
Views
Interface view
344