Ecmp Algorithm Settings; Route Redistribution; Route Redistribution Settings - D-Link xStack DGS-3620 Series Reference Manual

®
xStack DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide

ECMP Algorithm Settings

This window is used to configure the ECMP OSPF state and ECMP route load-balancing algorithm.
To view the following window, click L3 Features > ECMP Algorithm Settings, as shown below:
The fields that can be configured are described below:
Parameter
ECMP OSPF State
Destination IP
Source IP
CRC Low
CRC High
TCP/UDP Port
Click the Apply button to accept the changes made for each individual section.

Route Redistribution

Route Redistribution Settings

This window is used to redistribute the routing information from other routing protocols to RIP, OSPF or BGP.
To view the following window, click L3 Features > Route Redistribution > Route Redistribution Settings, as
shown below:
When selecting RIP as the Destination Protocol, the following window will be displayed.
Figure 6-18 ECMP Algorithm Settings window
Description
Click the radio buttons to enable or disable the ECMP OSPF state.
Tick the check box so that the ECMP algorithm will include the destination IP.
Tick the check box so that the ECMP algorithm will include the lower 5 bits of the
source IP. This attribution is mutually exclusive with CRC Low and CRC High. If it is
set, CRC Low and CRC High will be excluded.
Tick the check box so that the ECMP algorithm will include the lower 5 bits of the
CRC. This attribution is mutually exclusive with Source IP and CRC High. If it is set,
Source IP and CRC High will be excluded.
Tick the check box so that the ECMP algorithm will include the upper 5 bits of the
CRC. This attribution is mutually exclusive with Source IP and CRC Low. If it is set,
Source IP and CRC Low will be excluded.
Tick the check box so that the ECMP algorithm will include the TCP or UDP port.
216