Table of Contents
Advertisement
4 Web-based Switch Configuration
System > SNMP Settings > SNMP Trap Settings
The SNMP Trap Settings page provide user to Specify whether the device can send SNMP
Type
SNMP Authentication Traps
System Coldstart Traps
System Warmstart Traps
Port Link Up / Link Down
Firmware Upgrade State
Port Security Violation
Loopback Detection occuring /
recovery
Duplicate IP Detected
Trap notification if PoE Power
On / Off
Trap notification if PoE Power
Error
Trap notification if over max
power budget
Click Apply to make the configurations take effect.
System > User Accounts
The User Accounts page provides user to control user privileges. To add a new user by typing in a User
Name, Password and retype the same password in the Confirm Password and choose the level of
privilege (Admin, Operator, or User) from the Access Right drop-down menu, then click the Apply button.
User can modify existing user account in the User Account Table. To change the password, type in the Old
Password, New Password and retype it in the Confirm New Password entry field and select the Encrypt,
then click the Edit button. To delete the user account, click on the Delete button.
Also, the Password Encryption mechanism offer encryption of account password in config file.
Figure 4.30 – System > SNMP Settings > SNMP Engine ID
Figure 4.31 – System > SNMP Settings > SNMP Trap Settings
Description
Trap event of authentication failure.
Trap event of device cold boot up.
Trap event of device warn boot up.
Trap event of link state changes (link down/link up).
Trap event of firmware upgrade status (success/failure).
Trap event of violations for port security.
Trap events of state changes (detected/recovery) for
loopback detection.
Trap event when duplicate IP address detected.
Trap event of PoE powering state in port basis.
Trap event of PoE error.
Trap event when device supplies power over the max
power budget.
D-Link DGS-2000 Series Ethernet Switch User Manual
3
3
7
7
notifications.
Advertisement
Table of Contents
