Security > Mac Address Table > Auto Learning Vlan Settings; Security > Access Authentication Control > Authentication Policy Settings; Security > Access Authentication Control > Application Authentication Settings - D-Link DES-1210/ME Series Manual

4 Configuration
DES-1210/ME Series Metro Ethernet Managed Switch User Manual
VID: The VLAN ID of the VLAN of which the port is a member.
MAC Address: The MAC address entered into the address table.
Port: The port to which the MAC address above corresponds.
Type: Describes the method which the Switch discovered the MAC address. The possible entries are
Dynamic, Self, and Static.
View All Entry: Clicking this button will allow the user to view all entries of the address table.
Security > MAC Address Table > Auto Learning Vlan Settings
The Auto Learning Vlan Settings page allows you to enable or disable the auto learning VLAN feature.
Figure 4.143 - Security > MAC Address Table > Auto Learning Vlan Settings
VLAN List (1-4094): Enter the VID.
State: Specifies to enable or disable the auto learning VLAN state.
Click Apply to implement configuration changes.
Security > Access Authentication Control > Authentication Policy Settings
This feature will enable an administrator-defined authentication policy for users trying to access the Switch.
When enabled, the device will check the Login Method List and choose a technique for user authentication
upon login.
Figure 4.144 – Security > Access Authentication control > Authentication Policy Settings
Authentication Policy: Use the pull-down menu to enable or disable the Authentication Policy on the Switch.
Response Timeout (0 - 255): This field will set the time the Switch will wait for a response of authentication
from the user. The user may set a time between 0 and 255 seconds. The default setting is 30 seconds.
User attempts (1 - 255): This command will configure the maximum number of times the Switch will accept
authentication attempts. Users failing to be authenticated after the set amount of attempts will be denied
access to the Switch and will be locked out of further authentication attempts. Command line interface users
will have to wait 60 seconds before another authentication attempt. Telnet and web users will be
disconnected from the Switch. The user may set the number of attempts from 1 to 255. The default setting is
3.
Click Apply to implement configuration changes.
Security > Access Authentication Control > Application Authentication Settings
The Application Authentication Settings page allows user to configure switch configuration applications
(Console, Telnet, SSH, HTTP) for login at the user level and at the administration level (Enable Admin)
utilizing a previously configured method list.
90